Sealed Tite Trademark and Logo
Ruble Waterproofing Systems

Waterproofing Basements since 1985



Drainage Products
 
Insulation Products
 
NEW Construction
 
Structural Products
 
Contact Us
 
Home
-- We'll keep your basement 'Sealed Tite®'.



 
Ruble Waterproofing Systems
Drainage Products
 


AKWA Drain ™, drain strip and CactusBoard, floor edging
for new construction
and the Beaver® System used to waterproof pre-existing basements
.

AKWA Drain ™ Strip Drain
Used in New Construction

AKWA Drain  Strip Drain


AKWA Drain ™ is manufactured from a formed plastic core covered on one or both sides with a geotextile filter fabric. The fabric allows liquids or gases to be efficiently collected into the drain core and transported out through designated exits.
CactusBoard™ Floor Edging
Used in New Construction
CactusBoard for dry basements
CactusBoard preserves structural contact between the floor, footing and walls.
  CactusBoard ™ is a solution for new home builders that will keep the basement floor dry guaranteed. It is easy, inexpensive and warranted for 20 years.

CactusBoard™ is the only product that can ensure the floor stays dry regardless of what happens to the walls or footing drains. Just keep the stone bed under the floor drained, and your basement floor remains dry forever.

CactusBoard's™ unique dimpled design preserves structural contact between the floor, footing and walls.


The Beaver® System to
Waterproof your Pre-Existing Basement


Beaver waterproofing system for pre-existing basements
Drying up your wet basement is the first step towards a clean and healthy room ready for living, storage or play.

The Beaver system relieves hydrostatic pressure without jackhammers trenching through the basement floor or hauling mud and gravel in and out of your home. Hollow baseboards adhered to the floor along the wall act as a barrier collecting water from weep holes tapped into the blocks where the floor and wall meet. Water travels along the hollow baseboards to a drain or sump-pump.
  The Beaver® System is simple in design, but very effective. The system is composed of vinyl channels which resemble oversized baseboards and is a fairly inexpensive safeguard against basement flooding. This system can be used for poured concrete or block foundations. By tapping holes in the cement blocks at floor level you will lower the hydrostatic pressure that has built up in the walls. The Beaver system is then installed in front of the holes using Vin-Con-Lox adhesive. This simple system allow you to channel the incoming water to drain or sump pump. Water seepage ruins the comfort of your home .





Drainage Products | Insulation Products | New Construction | Structural Products | Contact Ruble | Home

© 2002 - 2004 Ruble Basement Waterproofing Systems All rights reserved.
CKFS Web Page Design
Best when viewed in IE with resolutions lower than 1280 X 1054